Future-automation PS60 User Manual download pdf (Page 11)

Installation: Stage 6

Page 10 of 12 // email [email protected] tel: +44 (0) 1438 833577 fax: +44 (0) 1438 833565

PS60 - Plasma Swivel Bracket

Fitting the Bracket to the Wall

Firstly, remove the bracket from the rear of the screen. Make sure that the uprights

are still left connected to the rear of the plasma screen.

Bearing in mind the relative distance from the top of

the plasma screen to the top mounting holes, place the

wall plate against the wall, and mark where the holes

need to be on the wall. Take care with making sure the

wall plate is level.

Bracket Position

It is important to remember the limitations of the bracket when deciding on its position on the wall.

The bracket enables a screen to rotate through a maximum of 45 degree clockwise and 45 degree

anti-clockwise from initially being parallel to the wall behind.

Wall Fixings

There are no wall fixings supplied with this product.

The wall plate has 10mm diameter holes for the fixings. Therefore, it is recommended that fixings

of minimum 8mm diameter are used.

It is recommended that either rawlbolts, large diameter plastic wall bolts, or resin anchors are used

to fix this product to the wall.

Suitability of fixings will depend on the type of wall the product will be fixed to.

1 2 ... 6 7 8 9 10 11 12 13 14

No comments

Future-automation PS60 User Manual Page 11